![]() ![]() Radar Installation Manual Standard Horizon Chart Plotter. Radar Installation Manual Radar Cable Radar On/Off Switch (Green & Blue wires from Radar Cable) Power / Data Swiched DC Power GPS Chart CP300 WAAS Figure 2.4 - Example of Connection Procedure for CP300 2.5 RADAR JUNCTION BOX CONNECTIONS Referring to the diagram below, connect the color coded wires from the Radar cable to the designated. Radar Installation Manual 12-24VDC JUNCTION BOX EXTERNAL SWITCH Green Blue Black White Black Orange Red Brown Y ellow Figure 2.3 - Antenna Cable 2.4 CONNECTION PROCEDURE NOTE In the following procedure the small wires must be stripped and tinned, and then connected to the proper connections in the Radar Junction Box, and to pins on the On/O. Working at higher elevations may become necessary. Invert the scanner and make sure the four mounting holes are clear to accept bolts. For ease of handling, coil the cable and place it on top of the scanner. Radar Installation Manual unit that are needed for installation or operation. #Horizon Lt 8001 Manual software#WARNING In order for the Radar Antenna to communicate with the Chart Plotter, the software must be configured as explained in the Par. INST ALLA TION This chapters illustrates the instructions on mechanical and electrical connections of the Radar and the necessary software settings to operate it. Radar Installation Manual PRODUCT SUPPORT INQUIRIES If you have any questions or comments, we invite you to visit the to send an E-Mail or contact the Product Support team at 80 M-F 7:00-5:00PST (in USA or Canada), Standard Horizon/Vertex Standard authorized dealers (Outside USA or Canada), or Si-Tex USA at. GENERAL SETUP When a word(s) is in bold capita. If you see brackets around a bold and small capital letter word this refers to a Soft Key press. INTRODUCTION 1.0 CONVENTIONS USED Please refer to the legend below: If you see brackets around a bold and capital letter word this refers to a key press. Radar Installation Manual T ABLE OF CONTENTS SAFETY PRECAUTIONS. ![]() Please read through this Installation and Connection Manual before the first operation. Radar Installation Manual MAGNETRON PREHEATING When starting your Radar for the first time or when restarting it after a two month or longer non-operating period, preheat the magnetron at least 30 minutes in stand-by mode. Technicians must exercise extreme care when working inside the. Only a qualified Radar service technician should remove the cover. There are no internal connections or adjustments necessary for installation. Radar Installation Manual SAFETY PRECA UTIONS HIGH VOLTAGE WARNING Dangerously high voltages are present within the Radar scanner unit. ![]() No part of this publication may be reproduced or distributed in any form or by any means, or stored in a database or retrieval system, without prior written permission of the publisher. Radar Installation Manual Copyright 2008. SI-TEX RADAR INST ALLA TION and CONNECTION MANUAL MDS-1 MDS-8 MDS-9 MDS-10-4/MDS-10-5. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |